Monday, September 15, 2014
Browse »
home»
amplifier
»
schematic
»
simple
»
Simple Amplifier Schematic
If the circuit above not working may cause as follows :
- Check voltage on the circuit , wether or not the voltage.
- Check wether the components are soldered onto PCB properly.
- Check input and output wether working or not.
- Check input output cable , if there are disconnected , or a short circuit. Or input connected with ground.
Simple Amplifier Schematic
This Circuit Use a IC BA515 for operation it. This is very simple Amplifier schematic , with only add 8 component , such as resistor and capacitor. Minimum voltage require 3 Volt , this also low voltage amplifier . And maximum voltage require 9 volt. Power output under 10 Watt with impedance 4 Ohm. This circuit is very suitable for small speakers.
See schematic below :- Check voltage on the circuit , wether or not the voltage.
- Check wether the components are soldered onto PCB properly.
- Check input and output wether working or not.
- Check input output cable , if there are disconnected , or a short circuit. Or input connected with ground.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment